A backflow preventer is a plumbing device designed to stop backflow—the unwanted reversal of water flow that can pull contaminants into a building’s drinking-water lines. Instead of water moving normally from the supply into your home or facility, pressure changes can force water to flow in the opposite direction, creating a potential health risk.

Backflow can occur when there’s a drop in water pressure on the public side (for example, during a main break or heavy demand). If your plumbing has certain connections or risk sources, contaminants may be drawn backward through the system.

What backflow preventers protect against

Backflow can move a wide range of substances into potable water systems, including chemicals used in irrigation, wastewater from drains connected to irrigation lines, or other contaminants associated with cross-connections. The goal of a preventer ... Read more »

Sump pumps are one of the few home systems that may sit idle for weeks or months—then suddenly need to perform flawlessly. That’s why establishing a service routine matters: it helps prevent clogs, failures, and water damage when you need the pump most.

While exact timelines vary by model and environment, a practical rule of thumb for many households is monthly testing plus seasonal maintenance. Below is a straightforward schedule you can adapt to your basement’s needs.

Monthly: test the pump and check for warning signs

At least once a month, test your sump pump’s switch and operation. For pumps with a float switch, confirm the float moves freely and the pump turns on when water rises. If your unit includes a high-water alarm, verify it’s functioning as well.

... Read more »

Hidden water leaks can waste thousands of gallons over time, often without obvious signs. The fastest way to investigate is to read your water meter correctly and then run a short “no-use” test to see if water is still moving. Here’s a clear, step-by-step approach you can do at home.

1) Find and identify your water meter

Most meters are located near the street or curb, sometimes behind a small access cover or in a landscaped box. Once you locate it, look for a clear label or markings that indicate how the readings are displayed. If your home has multiple meters (for example, separate meters for irrigation and indoor use), make sure you’re checking the right one.

2) Understand what you’re looking at: dials and digital displays

Water meters generally fall into two categories: digital and dial (analog). On a digital meter, t ... Read more »

For homeowners in Illinois weighing a boiler replacement, the choice often comes down to one question: will a condensing boiler save enough to justify the higher upfront cost? In many cases, the answer is yes—especially when replacing an older, less efficient “standard” (non-condensing) unit.

Both systems can heat your home, but they do it differently. A standard boiler primarily delivers heat that’s generated during fuel combustion, then vents the remaining heat up the chimney. A condensing boiler is designed to capture additional heat by condensing water vapor in the exhaust, improving overall efficiency.

Why condensing boilers usually win on operating costs

The key driver is efficiency. Condensing boilers can achieve significantly higher annual efficiency ratings than standard boilers by squeezing more usable heat out of the same amount of fuel. In Illinois’s cold winters, that ... Read more »